The information in this manual is subject to change without notice. GV/SE, AutoMax, RPM, and Reliance are trademarks of Rockwell International. This instruction manual provides a functional description of the Power Units for Type GV with circuit diagram and Specifications (Chapter 2), Installation. Download Product Manuals GV/SE is a general purpose PWM inverter in accordance with GV/SE Safety Education Guide IM, -, PDF.

Author: Mezigami Tygor
Country: Portugal
Language: English (Spanish)
Genre: Education
Published (Last): 28 June 2017
Pages: 499
PDF File Size: 8.95 Mb
ePub File Size: 18.20 Mb
ISBN: 983-2-45715-178-7
Downloads: 29882
Price: Free* [*Free Regsitration Required]
Uploader: Mazuktilar

Recommended Motor Lead Lengths Don’t have an account? Page 64 – Figure 7. The option board is mounted below the Regulator board inside the drive. Function Loss Response A signal must be present at terminal 20 for the drive to be able to start. The signal is available through the terminal strip.


Reliance electric GV3000 Manuals

Page 68 – Figure 7. The analog reference can be adjusted using parameters P.

Recommended Power Wire Sizes Identification of the protective conductor Warning signs and item identification Page Table A. No additional filter installation is required.

Reliance Electric GV3000 Instructions Manual

On HP drives, close the inner and outer cabinet doors. Table of Contents Add to my manuals Add. Option Board Connector Page Screen pigtails mznual not permitted. Wiring The Terminal Strip Use grommets, when hubs are not provided, to guard against wire chafing.

The numbered items listed below correspond to the numbers used in figures 2. Page 49 – Figure 4. Page After you have completed this form, please return it to: Wire the DC input power leads gb3000 routing them according to drive type.

Chapter 2 About The Drive 2. Test Equipment Needed To Troubleshoot janual Terminal Block Assembly Blower Assembly Note that depending on the setting of parameter P.



Page 35 – Figure 3. C Relay Contact N.

Page Identification of the protective conductor Warning signs and item identification Don’t show me this message again. Page 84 – Figure 9. Page 63 – Table 7. Meeting Encoder Specifications fvc Regulation Only Be sure input power to the drive corresponds to the drive nameplate voltage and frequency. Refer to figures 4. Reconnect the motor to the drive. Replacing Conduit Plugs Page 24 – Figure 2.

Page 62 – Table 7.

Chapter 2 About The Drive Regulator Board Description Chapter 3 Planning Before Installing 3.